Inan active system, we use a different means to shape the tweeter's response and to remove bass from the signal. We put the high pass filter BEFORE the amplifier. This provides lots of benefits. We're able to tune the system much more easily and we can implement nearly any filter, especially if we're using a DSP.Thefactory stereo system. The 2006-2012 Chevrolet Impala was offered with a choice of two factory stereo systems: The standard system, with an AM/FM/CD/MP3 receiver and six speakers. An optional Bose® system, with all of the above, plus two more speakers. Both of these systems offer about what you'd expect from a factory-installed stereo package.Configuration#1. Figure 1 shows a two-way loudspeaker, with the most popular tweeter placement. The woofer and tweeter share the same vertical center-line. Lobing is expected due to the offset design, and this loudspeaker does not disappoint. The crossover network is usually designed to make the lobes symmetrical above and below the listening
Yes in most cases, crossovers are necessary for tweeters. Crossovers are a type of electronic filter used to split audio frequencies from a single audio signal into two or more bands of sound. They are commonly used in loudspeaker systems, allowing the use of multiple drivers to cover a given frequency range more effectively than a single driver.
Adented or creased dome will have some impact on sound. For a crease, it may well be inaudible. A dome tweeter has a somewhat hemispherical radiating pattern. Imperfections in the dome that affect the shape will affect the radiating pattern. This is an issue for tweeters because the sound wavelengths are so small.
Standardmono speakers come with a single tweeter and a single bass driver. When appropriately connected to a receiver, the left and right sounds are streamed to the left or right speaker independently. A single stereo speaker, however, has a both a left and right tweeter, as well as a bass driver. This allows a single speaker to stream both
